My reshaped plate holder

[Blue70]

I just picked up this 2003 Buell XB9S on Monday.
Yesterday I took the tail piece to work and hacked on it.
I kept the turn signals for now. It's pretty bad around here, and I want drivers to clearly see where I am going.
I was going to make a plate light, but when I went to put my tail light back in, I noticed that the bottom part, below and behind the red part is already clear!
I was going to cut a slot in the aluminum, but I didn't have the stuff at home to do it, so I just drilled 2 holes for now.. it works :)
Anyway, here's how it turned out.

http://i5.photobucket.com/albums/y175/entrefal/Buell/Rear1.jpg

http://i5.photobucket.com/albums/y175/entrefal/Buell/Rear2.jpg

http://i5.photobucket.com/albums/y175/entrefal/Buell/Rear3.jpg

(Yes it does/did need a tire, I rode it to work today and had one put on at lunch)

http://i5.photobucket.com/albums/y175/entrefal/Buell/tire.jpg

and here is the light holes.. I will open them up and clean it up a bit later.. it looks red from the light coming in the tail, but it's a clear lens.

http://i5.photobucket.com/albums/y175/entrefal/Buell/Light.jpg

[LeFox]

fill the holes you drilled with some clear silicone so water can't infiltrate ;)

[Blue70]

The holes are only in the aluminum.
The taillight is still sealed and untouched.
The holes do not go into the plastic taillight housing [up]

[Fock347]

looks like that bike has been droped b4 , the header pipe has a nice ding in it.

[BuellPartsGuy]

All other things aside, you need tires!

[Blue70]

Yes, the bike has been down, (not with me yet)
There is a ding in the pipe and there was a scuff on the passenger foot peg too.

As I said above, I got new tires already :p