Muffler glasspack

[MotoX6]

What brand mufflers does everyone use to build their mufflers? I found magnaflow an thrush to be possibilities?

[tuneport67ss]

I got mine on eBay. It is a guy that specializes in mustangs. Mine are 2 1/4"x12". The fit and sound is great. I liked them because the pipe can weld straight to the muffler body instead of adding the extra 2-3" for the typical pipe flange. I will try to find the link and add it on here.

The eBay item# is 250799618218

They are pretty cheap, but are well built. Another guy on here built his using the exact same mufflers. Hope this helps.

[brandan86]

http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=250799618218&ru=http%3A%2F%2Fshop.ebay.com%3A80%2F%3F_from%3DR4 0%26_trksid%3Dp5197.m570.l1313%26_nkw%3D2507996182 18%2B%26_sacat%3DSee-All-Categories%26_fvi%3D1&_rdc=1#ht_500wt_1156

thats not to bad, Im thinking about putting a glasspack or something on my Blast

[MotoX6]

how well do they mount under the stock brackets? i wanna save the stock exhaust so i wanna add a down tube and add the chin fairing mounts.

[tuneport67ss]

I used metal brackets welded to mine that fit the stock filter and chin spoiler. I hand made all of that. I dis drill a hole in the center if the rear crescent shaped bracket so I could put a bolt through it for the rear of my pipes. I too wanted to keep it where my stock muffler would go back. I can actually swap them out in less than 30 min between the two.
I will try to post a link to my build here in a little bit so you can get a better idea.

Muffler build (http://www.buellxb.com/Buell-XB-Forum/Do-It-Yourself-Buell-Mods/And-Another-New-Muffler-Build)

[brandan86]

tuneport, that is a very nice exhaust.I wish I had a welder. Life would be so much easier

[tuneport67ss]

I have actually thought about selling mine and building something different. I actually want to go with more of a true straight pipe or building a chambered design. Not real sure what I want to do, but as the saying goes " money talks". Lol.

[MotoX6]

Thanks tune port that's a sick pipe. U might try somethin like that only possibly the y tube in middle....course either way it'll be sweet

[tuneport67ss]

Ya I was going to go centered on the Y but I decided to go in onthe left side like I did since the factory pipes kind of runs across and to that side then down. Also made the brackets for the chin spoiler a whole lot easier to fab up.