Headers

[BuellSki]

Has anyone on here that is too cheap to buy the race headers. Build your own. I'm a welder by profession. So that aspect isn't a problem. I was gonna buy all the bends the same size as the race ones. And just use the stock flanges and expand them out to the proper size and get a picture of the race headers and build the exact same ones. At a quarter the cost. If any body has how'd they turn out and was there any problems that you came across. Post pictures if possible.
Thanks
BuellSki

[iman501]

Sounds like you could make some money off that idea to if it works out!

[BuellSki]

So nobody has any input. Or has done this.

[victormonopoly]

I'm gonna be doing the same thing. I'm certain someone here has, I've seen it in a photo. I'm just not sure who.

[TACPBuell]

bajabomber has made his own headers and has them for sale also last i checked.

[blove]

I built a set of headers when I attended Wyotech. I know it wasnt easy but then again it was for Chevy 350 full race headers. I do know the hardest part was getting the headers to be the same capacity. I ended sealing them up and filling with water and then weighing the water to check capacity on each line. I dont know if this helps you in anyway though. Good luck.

[BuellSki]

Yeah I didn't even think about capacity.
Thanks
BuellSki