Ok so I ordered a brand new header to polish. I forgot to take a pic of what it looked like at first. Just to give you an idea it looked like dull stainless steel. Looked ugly.
Ok first I grabbed PB Blaster and a Scotch Brite (Green Pad), Soak the green pad in PB Blaster and start (stroking your pipe) HAHA. Its a pain in the butt took me about 1.5 hours to get the dull look off. Clean pipe good with paper towels.
Next I did the same thing but with Never Dull. Good arm work out by the way. Clean pipe again with paper towels.
Then I placed the Mothers Power Ball on the drill press. Lube up your header with the Mothers polish. Do about a 6 inch section at a time and buff it out with the power ball. Clean with paper towels, I found them to be better than a rag.
Lastly go over the entire header again applying Mothers polish with a paper towel and then buffing clean with a paper towel (I used a entire roll).
Took about 2.5 hours when said and done.
So here is the finial pic, What do you guys think?
Ok first I grabbed PB Blaster and a Scotch Brite (Green Pad), Soak the green pad in PB Blaster and start (stroking your pipe) HAHA. Its a pain in the butt took me about 1.5 hours to get the dull look off. Clean pipe good with paper towels.
Next I did the same thing but with Never Dull. Good arm work out by the way. Clean pipe again with paper towels.
Then I placed the Mothers Power Ball on the drill press. Lube up your header with the Mothers polish. Do about a 6 inch section at a time and buff it out with the power ball. Clean with paper towels, I found them to be better than a rag.
Lastly go over the entire header again applying Mothers polish with a paper towel and then buffing clean with a paper towel (I used a entire roll).
Took about 2.5 hours when said and done.
So here is the finial pic, What do you guys think?
