View Full Version : front left blinker not working
RedSphinxy
08-19-2012, 10:57 PM
I recently dropped my 'o4 Blast and the front left turn signal was destroyed. I replaced the signal, but it still isn't working. The signal itself is fine, I plugged it into the opposite bullet plug to make sure it wasn't an issue with the new part. All the other turn signals work completely normally. Any ideas of what could be wrong to only make one signal stop? If it was the flasher wouldn't all the signals stop working?
07Bolt
08-19-2012, 11:06 PM
Check the bulb
RedSphinxy
08-19-2012, 11:13 PM
The bulb was brand new, but I did check it. The turn signal works fine when plugged into the bullet plug for the right turn signal. It just doesn't work when plugged into the left turn bullet plug.
07Bolt
08-19-2012, 11:38 PM
Then theres no power to the bulb, did the crash yank the wire loose?
RedSphinxy
08-19-2012, 11:45 PM
Do you think I can rule out the flasher being broken because it still makes the clicky noise and the other signals work fine? I just want to rule it out before I start tearing into the wires
Buell_Cru
08-19-2012, 11:56 PM
Change the fluid...
netty2424
08-20-2012, 12:02 AM
^lol! I was waiting for that to pop up!
Utahbry
02-24-2013, 11:14 PM
Got the same issue, difference is the bike hasn't been laid down. It started intermittently, when i sometimes would make a left turn i would notice the left turn signal in the front would stop working, the indicator on the speed o would click 2X faster then normal....... this went on for a while hit and miss never consistent until finally it just stopped blinking at all in the front. replaced bulb. nothing....
Any suggestions??
Thanks
enicar1
04-16-2013, 07:09 AM
Same thing happened to mine. Wire connector pulled free. Or you might have pinched the wire ...
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.