camouflage
Well-known member
- Joined
- Mar 4, 2013
- Messages
- 96
Hi folks, This is my first post after lurking around these boards infomation gathering for a quite a while after purchasing a 2008 XB12SS Long. (which I absolutly love btw 
)
My bike has an EBR ECM, Jardine pipe and I am just about to do an open air box mod on it. I purchased ECM Spy to do all the cool code and mapping stuff but started getting a "Failed to get firmware version" message every time I scanned. I then found out I had an EBR ECM (by looking at the part numbers on the ECM case) and when I went to fetch EEPROM it suddenly all connected and pulled the EEPROM and the MAP from the ECM.
I still have a problem when trying to read trouble codes it still throughs up the "Failed to get firmware version" message..................
Is this because EBR ECM and ECM spy are not compatible or have I made a error some where?
Do I need a different software to interigate an EBR ECM?
)My bike has an EBR ECM, Jardine pipe and I am just about to do an open air box mod on it. I purchased ECM Spy to do all the cool code and mapping stuff but started getting a "Failed to get firmware version" message every time I scanned. I then found out I had an EBR ECM (by looking at the part numbers on the ECM case) and when I went to fetch EEPROM it suddenly all connected and pulled the EEPROM and the MAP from the ECM.
I still have a problem when trying to read trouble codes it still throughs up the "Failed to get firmware version" message..................
Is this because EBR ECM and ECM spy are not compatible or have I made a error some where?
Do I need a different software to interigate an EBR ECM?
