07 xb12stt tps voltage low, help!

[jeshua]

I need some help.


i replaced my TPS after doing the diagnostic check in the manual for code 11 (TPS too low/short to ground) and went to reset the TPS after replacing it and my voltage is not right. i am getting 0.49 v constant no matter what the throttle position is and the bike is still throwing a code 11. With the old TPS i was getting 0 constant. I did the check list in the manual and i had continuity between the ecu and connector 88. what do i need to look at now. Bad ground???

I used the duralast# TPS213 per another thread on the forum.

Also my battery is no good after doing all this testing it isn't holding a charge any more, going to drop it off at the shop tomorrow just to verify.

[BuellyBagger]

That tps shouldn't fit a 07. They have a different throttle body shaft pin than the 04-06. If I wasn't on my phone I'd post the service bulletin about it. google it...that's how I found it. i'm not. blowning smoke,I put a tips in my 07. Even got the part you did and found it was wrong. The pin orientation is about 90° different between the two

[BuellyBagger]

what I went through a year ago (http://www.buellxb.com/Buell-XB-Forum/Buell-Ulysses-XB12x/Troubleshooting/Trouble-Code-11-diagnostic-help)

If you're gonna keep working at it make sure to follow your service manual. Helped me a bunch

[jeshua]

Thank you.
I'm checking your old thread out i hope i don't need a new ecu