View Full Version : Wanted--Any after market muffler.
Kole_DeWoody
02-23-2009, 04:19 PM
Does anyone have any after market mufflers they want to sell Ex. Jaridine,D&D, ect?
Not wanting to spend a whole lot. If you know of anything please post.
nitto12ss
02-24-2009, 05:19 PM
I have a Voodoo LD W/internal elbow and duel outlets I could part with. I bought it two weeks ago and its to loud for my taste, so I am keeping my Voodoo DIY exhaust and letting this one go. $300 + free shipping to the lower 48. Also note that this is a preproduction pipe, so there is no "for race use only" stamp.
Picks http://i429.photobucket.com/albums/qq19/turf2/IMG_1945.jpg?t=1235510091
http://i429.photobucket.com/albums/qq19/turf2/IMG_1944.jpg?t=1235510121
http://i429.photobucket.com/albums/qq19/turf2/IMG_1943.jpg?t=1235510148
http://i429.photobucket.com/albums/qq19/turf2/IMG_1942.jpg?t=1235510194
http://i429.photobucket.com/albums/qq19/turf2/IMG_1941.jpg?t=1235510220
Kole_DeWoody
02-24-2009, 07:36 PM
Nice but more then i have i can only spend about 250
Kole_DeWoody
02-24-2009, 07:38 PM
btw how loud is it?
nitto12ss
02-24-2009, 07:44 PM
On the freeway it is not bad, but around town it is two loud for me. I had my dad ride the bike so I could hear it from a different perspective and it was not to bad, but if I were to keep it I would wear ear plugs. If you are still interested 250 will be close enough.
Kole_DeWoody
02-24-2009, 07:53 PM
My i am if it has a deep sound i know some of those pipes end up sounding tinny thats the big thing i am worried about if its deep i am interested.
nitto12ss
02-24-2009, 08:13 PM
Here are some drive by videos of the pipe.
http://s227.photobucket.com/albums/dd72/tattoo72666/?action=view¤t=2005_0101Holiday0052.flv
http://s227.photobucket.com/albums/dd72/tattoo72666/?action=view¤t=2005_0101Holiday0051.flv
It sounds better in person, but my Voodoo DIY is deeper in sound, but this in NO way will sound tiny.
Kole_DeWoody
02-24-2009, 08:20 PM
Ok i will take it my email is
[email protected]
nitto12ss
02-24-2009, 08:32 PM
Check you email.
nitto12ss
02-24-2009, 08:44 PM
I cant seem to email you. I guess you can try me at
[email protected]
Kole_DeWoody
02-24-2009, 08:49 PM
email sent and i bet you forgot the _ its Kole_DeWoody
nitto12ss
02-24-2009, 08:55 PM
Info sent :D
stopie20
03-14-2009, 11:27 AM
So, it looks like I am the new owner of this pipe. Is there any way I can get as much info as you have on it... I want to know if you were able to install this pipe and not have any of the gremlins that need to be "tuned" out, i keep reading almost everyone on here that adds a pipe has to tune to some extent. I dont care about how loud it is that is a nonissue any help would be great.
nitto12ss
03-14-2009, 06:26 PM
Stopie20, the pipe worked fine for me, it was just to loud for my taste. I bought the pipe with the intent of keeping only one of my aftermarket pipes. I liked my Voodoo DIY better, so I sold the pipe that is now in your possession. From my experience with the muffler "which is only one ride" is that it will work fine without a retune. Just let the ECM relearn the pipe by Going on the freeway and cursing at a constant RPM between 3400 and 3800 for a few minutes and you should be good to go. But to truly gain the full potential of the pipe you should get a retune.
Hope that helps
Walter
stopie20
03-14-2009, 09:38 PM
Thanks, that is very helpfull, but is it safe to curse above 2500 RPM?...:D
nitto12ss
03-14-2009, 10:01 PM
One thing I forgot to ask is have you performed any other performance mods? The stock ECM will only adjust so much and can only handle about one mod, any more than that and the bike will run to lean.
stopie20
03-18-2009, 01:21 PM
no other mods, just the pipe for this summer, I dont think the gains to be had are worth the air filter or just tuning... over next winter I will most likely be doing a big bore kit, heads, cams and then I wil be doing a but load of tuning,... or maybe just a bolt on cold air turbo?
XBen12
03-19-2009, 05:23 PM
hey stopie20, hows the pipe?
stopie20
03-20-2009, 07:52 AM
Still on the bench. I was going to install, but decided to wait for my seat rails to get back from powder coat so once the pipe is installed I can immedeatly get on the highway (for the ECM to do its learning thing)dont want to sit in the garage revving the engine if its running too lean... i may post a sound clip and update once installed.
XBen12
03-25-2009, 06:15 AM
please post a clip & thoughts! :D
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.