Request for 1125R/1125CR Stock EEPROM image

[ReadyXB]

Does anyone have a stock eeprom image for a 1125R/1125CR (any year) that they could post, or point me to?

Thanks.

[buellxb9rs]

Whenever I get my bike switched from ddfi2 to ddfi3 I will hook up to it and download it. Not sure when I will get around to it so hopefully someone else can help you out before then

[ReadyXB]

Awesome - thanks. Yeah, hopefully someone else will have it downloaded, though. I was surprised there wasn't an 1125 eeprom image on buellmods already.

[Kruizen]

Whenever I get my bike switched from ddfi2 to ddfi3 I will hook up to it and download it. Not sure when I will get around to it so hopefully someone else can help you out before then
How do you have an 1125 with DDFI2?

Readyxb you need to know what version the ECM is flashed with because as I understand it they moved values around within the ECM and didn't just change the values with each flash.

[buellxb9rs]

I don't, I have an XB9, but I am making the harness and using the ECM from an 1125 so that I can have 2 02 sensors, etc

[ReadyXB]

Readyxb you need to know what version the ECM is flashed with because as I understand it they moved values around within the ECM and didn't just change the values with each flash.
I should have explained - I need to look at certain settings in the EEPROM from an 1125. See this thread (http://www.buellxb.com/Buell-XB-Forum/Buell-Firebolt-XB12-XB9/Troubleshooting/Lowest-Load-value-doesnt-seem-low-enough). I won't need to flash it into any ECM. It would be nice to know which version of ECM the eeprom corresponds to so I can match up with the appropriate .XDF file, though it would be easy to figure out by trial and error.