So i just got the lowering pegs...

[Constantine]

So I just got the lowering pegs and I was able to adjust the shift lever with no problem, but I can't figure out how to lower the brake.

Thanks!

[LeFox]

which lowering pegs?
maybe a picture to get a view on things?

think it's just adjusting the angle in which it's fitted.

[Constantine]

This is not me, but here is a picture of the peg, as well as a walkthrough I found of the procedure, however if you read it at the end the dude who did this also could not figure out how to adjust the brake.


http://www.vfrdiscussion.com/forum/uploads/1127150703/gallery_4208_389_5984.jpeg

[LeFox]

ok, at the rear of the brake, you can adjust it a bit.
at the brakelight switch you have a bolt with 2 nuts.
step 1: loosen the lower one.
step 2: adjust the upper nut, you'll see that the brake-peg is moving (up/down depends on which way you're turning)
step 3: when in desired position, tighten the lower nut again.

dubbelcheck: you can not lower the brake that much, you still need some movement space for the brake-light switch and brake before they engage.
so unless you adjust the brake-switch too, you're brakelight and brake will be on all the time.

other option is to buy another brake-peg

hope this helps ;)

[Constantine]

Thanks, you were right. I tried that before but there is a rubber gasket over that top nut and I wasn't sure if I was supposed to move that, but it worked out.

[LeFox]

glad to help ;)