ecm spy loading maps?
- Thread starter BuellyBagger
- Start date
Help Support Buellxb Forum:
Hello,
My first post over here.
I have a uly 2008.
Somebody had success with the maps on https://sites.google.com/site/ecmspy/xb12/2008?
I'm trying to figure out why my idle rev is ca 1500rpm and not 1050rpm.
Sometimes i got also an hickup when pulling gas from idle.
Done:
-replaced stock exhaust with sebring open exhaust
-k&n filter
-breather reroute
My first post over here.
I have a uly 2008.
Somebody had success with the maps on https://sites.google.com/site/ecmspy/xb12/2008?
I'm trying to figure out why my idle rev is ca 1500rpm and not 1050rpm.
Sometimes i got also an hickup when pulling gas from idle.
Done:
-replaced stock exhaust with sebring open exhaust
-k&n filter
-breather reroute
WileyXB12X
Well-known member
- Joined
- May 8, 2012
- Messages
- 84
I dug this thread up trying to find out how to load maps and where to find maps to load and try out. I tried the maps from the ecmspy link above. The one Uly map won't load (it's BUEGB and my ECM is BUEIB) but the two 2006 BUEIB maps give me the following error:
LJIvasiv82
Member
- Joined
- Jul 1, 2016
- Messages
- 16
Your idle is set incorrectly than. There is an idle screw located between the left scoop and engine (believe 09 models no longer have screw). See this thread - http://www.buellxb.com/forum/showthread.php?47042-idle-adjustment-screw
You also can do a TPS reset and adjust this via ECM. I'm no expert, just ideas where you can turn to. Google "Buell Ulysses adjusting Idle" to read up more. There is also a 1400rpm cold idle and a 1100rpm warm idle, maybe that's what you're seeing at first?
My 2008 XB12X also hickups at low rpm (1100-2000) when initially pulling on gas, especially if the bike is not fully warmed up. From my research the bike was adjusted to run lean in low RPMs to stick within government regulations. Flashing a race ECM or adjusting the fuel tables will fix this.
You also can do a TPS reset and adjust this via ECM. I'm no expert, just ideas where you can turn to. Google "Buell Ulysses adjusting Idle" to read up more. There is also a 1400rpm cold idle and a 1100rpm warm idle, maybe that's what you're seeing at first?
My 2008 XB12X also hickups at low rpm (1100-2000) when initially pulling on gas, especially if the bike is not fully warmed up. From my research the bike was adjusted to run lean in low RPMs to stick within government regulations. Flashing a race ECM or adjusting the fuel tables will fix this.
Chicknstripn
Well-known member
Check the date on the post you're replying to.
It's over 3yrs old.
Happens to the best of us
It's over 3yrs old.
Happens to the best of us
LJIvasiv82
Member
- Joined
- Jul 1, 2016
- Messages
- 16
Yea I noticed right after posting. Figured I'd leave that info there incase someone's researching the same problem... 8)
