c818919taylor
Member
- Joined
- Oct 4, 2020
- Messages
- 6
What torque wrenches do you use help keep your EBR going?
torque wrenches
- Thread starter c818919taylor
- Start date
Help Support Buellxb Forum:
34nineteen
Well-known member
Aha! Another trick question!
To properly use one, means someone needs to have a service manual to get the torque values.
To properly use one, means someone needs to have a service manual to get the torque values.
Last edited:
Cooter
Well-known member
What torque wrenches? I use a 3/8" drive for most of the stuff, but switch to the 1/2" one for the rear axle. It's 100ft/lbs on the EBR where you just torque the axle just once*
*Thats very different from what you'll find in an Buell 1125 manual that says to go 25ft/lbs, un-wind 2 turns and re-torque to 50ft/lbs. But no one would use a manual from a completely different motorcycle to repair their EBR, would they?
*Thats very different from what you'll find in an Buell 1125 manual that says to go 25ft/lbs, un-wind 2 turns and re-torque to 50ft/lbs. But no one would use a manual from a completely different motorcycle to repair their EBR, would they?
Similar threads
