• You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will see less advertisements, have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!

    If you have any problems with the registration process or your account login, please contact us.

Search results

Buellxb Forum

Help Support Buellxb Forum:

  1. M

    red engine light

    So it was the oil light that lit up and not the management light .
  2. M

    00' x1 tune for straight exhaust

    You need to datalog with ecmspy then run logs through megalog viewer to adjust the maps.
  3. M

    new to buell, x1 with 20k, runs poorly

    get ecmspy and learn to use it, a must have with an x1, you can then see if your sensors are dodgy, reset the tps, load race maps(also a must have), check the AFV etc etc. make sure your battery is good and is charging, make sure the earths(grounds) are clean. Check your wiring connectors are...
  4. M

    New X1 owner

    http://www.saintjohn.nbcc.nb.ca/Marriott/x1/ some interesting and helpfull advice.
  5. M

    New X1 owner

    Make sure your battery contacts are clean and tight, same applies to the frame and engine earths, also take the end plate off the solenoid and inspect/clean the contacts and slip ring.
  6. M

    New X1 owner

    Throw the revtech box in the trash now. they are known to upset the buell ddfi and cause problems. Good that you have the race ecm, get ecmspy plus the cable to connect your laptop to the bike. With it you can check error codes, reset tps, data log etc etc. A must have with the x1. See...
  7. M

    High AFV

    its running lean or thinks its running lean, you might have a poor connection/break on the lambda wire, if its burning oil, is the lambda getting fouled up . Running lean, re check the intake seals, injector seals, injector stuck closed, fuel filter blocked, low fuel pressure and check your...
  8. M

    Looking for race map for 2001 X1

    get ecmspy, a lead to connect bike to laptop and megalog viewer then tune your own maps to suit your set up. read the tunning guide at www.ecmspy.com
  9. M

    99 X1 Ignition Problem

    Get ecmspy and a lead, a must have tool for fuel injection buells, with it you can reset tps/afv, run diagnostics and check timing etc etc
  10. M

    Popping/backfiring when letting off gas....

    i think there is a post on bad web where they say the EBR ecm cannot be altered with ecmspy and EBR dont do ecm's for tubers., but i might be wrong. You dont need a race ecm, you just load race fuel and timing maps onto your stock ecm with ecmspy, job done.
  11. M

    new buell owner

    its home made, the front shock mounting is the same on an m2 and x1. if you lower it by this method then you might need to shorten the side stand depending how low you go. I also dropped the forks in the yokes by about 3/4".
  12. M

    new buell owner

    Its an adjustable front shock mount i made to lower an x1
  13. M

    2000 X1 HELP

    www.ecmspy.com for usefull tunning guide and other info.
  14. M

    2000 X1 HELP

    have you got ecmspy and cable ? if not get it and learn to use it (easy), you will struggle to maintain the dfi without it. Running out of fuel is not a good idea on an x1,the ecm sees a lean mix and adds more fuel to compensate. You need to reset the AFV with ecmspy also reset the tps and check...
  15. M

    Lowering 2001 M2 Cyclone

    i made this front shock mount to lower my x1, adjustable to get it right.
  16. M

    X1 wont start

    bike started to rattle in the crankcase halfs, stripped the motor, turns out i need a crankshaft, two cylinders/pistons and two heads, all the origionals damaged.
  17. M

    X1 parts

    Parts needed for my 1999 X1 I need a rear head and piston, front cylinder exhaust valve and guide, oil pump, crankshaft con rod set (POSSIBLY S&S OR A NEW CRANK), pin bearings (big end) gone on mine. complete gasket set, output sprocket bearing. I am in the uk and will pay shipping. parts this...
  18. M

    1997 Buell M2 Front Rotor Question

    replace the front rotor with ebc dic MD734RS
  19. M

    lean running x1 need help

    could be an air leak in the intake ? get a race map off someone and load into your ecm (save your old map so you can put it back if things dont work out). my x1 runs a buell race exhaust which has no baffles, a foam performance air filter and a race map in the ecm, goes like a rocket with no...
  20. M

    X1 wont start

    turns out its not a vance and hines exhaust, it a buell pro system, anyone got fuel maps for this system ?, can compare to mine, give me an indication what figures i should be looking for.
Back
Top