-
You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will see less advertisements, have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!
If you have any problems with the registration process or your account login, please contact us.
BARO Sensor and Fuel Pressure HELP!
- Thread starter r1pp3r
- Start date
Help Support Buellxb Forum:
user_deleted
Well-known member
good morning CHICAGO! what happened here is very unusual. when your fuel pressure sensor inter-acted with your MAP sensor somehow there was an inverse flow or perhaps even a polarity reversal causing a substantial pressure drop along with a binary-code drop-out. that's the bad news. good news is that Rockwell Corp. manufactures a Buell-specific current reactive diagnostic tool to not only identify where your wave-length went astray but also to recalibrate both sensors. see vid. their rep will walk you thru the process.
let me also add that you need an additional interactive ground-source system installed on your buell to prevent future occurrences. board member John Vreede aka JV has run approx. 3900 feet of assorted ground wires and cables all over his Buell including a 10 foot tall lightning rod attached to rear fender "just in case". contact him for further info.
let me also add that you need an additional interactive ground-source system installed on your buell to prevent future occurrences. board member John Vreede aka JV has run approx. 3900 feet of assorted ground wires and cables all over his Buell including a 10 foot tall lightning rod attached to rear fender "just in case". contact him for further info.
Cooter
Well-known member
Good morning R1pp3r, welcome to the forum
The answer is "No"... but.
These funny guys above are trying to say to start from the basics. It's hard enough to diagnose something without ever seeing it, much less with no info provided to help.
What tools are you using to diagnose it? ECMDroid? ECMSpy? TunerPro?
When you "lost the BARO sensor" have you replaced it? or did you just uncheck the box in ECM perameters?
Does the bike run normally with the FP sensor disconnected?
The answer is "No"... but.
These funny guys above are trying to say to start from the basics. It's hard enough to diagnose something without ever seeing it, much less with no info provided to help.
What tools are you using to diagnose it? ECMDroid? ECMSpy? TunerPro?
When you "lost the BARO sensor" have you replaced it? or did you just uncheck the box in ECM perameters?
Does the bike run normally with the FP sensor disconnected?
wickedchop
Well-known member
EVERY word that dude used in the video got me hard! Lmfao.....wtf John
user_deleted
Well-known member
gotta tell ya wally i initially was "soft" on him. the bland gray suit...lack of facial piercings or ink.....the swept-back Bouffant hairdo....the lackluster entrance.....all a huge turn-off for me. then he began to speak and within seconds i was throbbing and ultra rock-hard. thought i had just taken a fistful of Viagra.
rchuff
Well-known member
^^^^^^^Lmfao!!!!!!!
