ecm-configure question

[migs16]

if i have a unstable idle after i go for a long ride and she gets all hot, can i uncheck the "idle ignition timing adj. enable"??? or would it be the "idle closed loop"???

ive done alot of megalogging to get my idle set but it still gets unstable when shes hot. it goes from 1100 rpm-850rpm.

 

[dallasb]

What does the fueling look like? If you watch your bike when it idles, on both the race and stock map, it will go in and out of 4 different cells. This can cause an erratic idle. The way I fixed mine was adjust the first rpm column where when my bike was idling it would stay in that one single block. Also what is the degrees of your tps? I wouldn't turn off any type of correction for long periods of time but it shouldn't hurt anything for just a short test.

 

[migs16]

ya i have done that alot was megalog just the idle for it can be still and stable. and i have my tps at 5.9 i like it the most there. il keep messing with and see what happens.

 

[dallasb]

You didn't adjust any of your idle corrections did you?

 

[migs16]

like on the map? ive been thinking of just adding fuel to the cells that the idle sits in. is that what you did?

 

[dallasb]

No its in the advanced tab IIRC. You can try just adding fuel if you wanted. Could be a leaking injector as well. What is the AFV on your bike at idle?