Fender eliminator?

[paulr]

What are my options[confused] for the eliminator kits? I'm getn a stainless d&d slip-on, barend mirrors, K&N filter, have it tuned, and the eliminator kit. I bought this new bike while I was stil payn on my lightning so I'm goin all out with this one. I want this bike to look really nice. Thanks all.

 

[dave_xb12r]

I think the jardine fender eliminator kit is the cleanest.

I've seen ASB's billet fender eliminator. It's very high quality, but it's too damn expensive. The jardine is $100 less than ASBs putting it around $65

 

[paulr]

Awesome! I thought all kits were a couple hundred plus so $65 bucks is right up my alley. Got a link to any places that have a good business reputation or should I just google it?

 

[dave_xb12r]

You can buy directly from Jardine, or you can get it on amazon. Click here for amazon link

 

[browland]

save 60 bucks chop the stock yourself and paint it with spraypaint

 

[Stevenc150]

Here's a DIY if you're considering: Fender Chop DIY.

 

[paulr]

Thanks for postn so fast guys. Just to make sure, this is for my cr right?

 

[paulr]

disregard, I didn't read enough.

 

[millenniumx1]

I liked the Jardine. Think I got mine from A S B, but not positive. Either way it was about $65, clean install, looks great when done. You'll note in the attached picture that I cut away the under-tail plastic to let the white part of the taillight shine onto the plate. Yes, same kit for the CR as what I used on my '09R.

Mike

 

[Stevenc150]

Just to make sure, this is for my cr right?

It's Dave's fault, I was following his lead. Actaully the concept of the link I posted still applies.

 

[03Firebolt9R]

I have the Jardine just like Mikes pictured above and like it alot.

 

[paulr]

bought it 20 min ago on amazon. thanks fellas. [up]

 

[RT Performance]

Little late but gr harley has them in stock
not sure they have them on there web page
wish I had an extra firebolt plate frame i would jut build the filler panel

 

[paulr]

does this kit keep the stock blinkers???

 

[RT Performance]

yes

 

[braindead]

Will the Jardine fit the xbs

 

[paulr]

Is this new fender hard to put on or is there anything specific I need t know. My instructions are faded and I'm gona try and just figure it out.

 

[paulr]

bump

 

[gear2078]

Hey Paul, I haven't installed a new tail yet, still trying to design my own. All I can tell you is that I had to pull both seats off and the top plastic off of the tail section to safely unplug two turn signal wires that were too short to get a hold of. Other than that, if you have two hands you can do it.

 

[AZCRrider]

Has anyone tried the Evotech fender eliminator? It has the integrated license plate LED. I'm still trying to decide myself.