Firebolt turn signal replacement?

[MotoX6]

Hey guys I got a new rear left turn signal for my bike and I can't find my manual! Does anyone know how to do it and can explain? It's stock to stock. Just don't know if you can do it without taking off the rear plastic or not?? Thanks!

 

[bigflash1]

Looking at mine, it looks like you could get there if you can coax the plastic trunk pan out. Haven't tried it but....
The service manual says:
Remove seat See 2.38 SEAT.
2. Remove tail frame upper body work. See 2.36 SUBFRAME
TAIL ASSEMBLY AND BODY WORK.
3. See Figure 7-52. Disconnect bullet connectors on turn
signal wires.
4. See Figure 7-51. Remove fastener (6) and lockwasher
(5).
NOTE
In next step, reflector bracket (3) will be removed with turn
signal (1).
5. Remove turn signal from tail section (7) and license plate
bracket (4).

 

[firefighter1c57]

remove front and rear seat. Remove two bolts in tail fairing near airbox, remove one bolt in rear fairing near rear seat. Remove two bolts in rear fairing underneath rear fairing behind passenger pegs.(all can be removed without removing anything else.) Spread rear fairing and slide back, unplug taillight and finish pulling rear fairing. Change turnsignals.

 

[MotoX6]

If you combine these two ^^ it works perfect. Thanks guys! Real easy fix

 

[creeping death]

i just pulled the plastic lining from under the rear seat and was able to get to them with a wrench. just did it Monday.