Hey pdksh!

[34nineteen]

Please keep your bad luck on your side of the border! :mad-new:

Your pal,
34:19

 

[Cooter]

Oh no! Thats gonna need a big heli-coil:concern: Sorry for the bad luck.

What job are you doing? Something including CC's I hope:angel:

 

[34nineteen]

I already had the extra CC’s courtesy of Dan at NRHS, but noticed a small base gasket oil leak at the rear left cylinder stud area. Since I was installing an new exhaust, I figured i would tackle it as I’m part way in. The pulled stud is on the forward right position. Luckily, the hole is blind and appears to be a clean pull.

Now... to helicoil or timesert?

 

[pdksh]

Sounds like you have this one under control. I stripped the oil drain plug on my Honda Accord. Hate that feeling when the wrench just slips.... it’s the feeling of a ****e day!
Haven’t stripped a buell bolt yet. But I have a rear caliber mounting stud that makes me nervous every time I take off the rear wheel (usually to change wheel bearings)

 

[Cooter]

I thought torqued meant tighten until it gets loose, then 1/2 turn?:applause:

Theres enough meat around that hole that either repair should be stronger than stock. Just go with what you like.

 

[34nineteen]

Dan from NRHS recommended a timesert, and a specific one tailored to this issue with this motor.

So now... I wait...


until Wednesday.