Installed power commander, wont start

[lively13]

Hi, so I just installed a HMF slipon, K&N Filter and last but not least the PCV., after installed the PCV the bike would not start (would not turn over or anything, it was like pressing a useless button.) However when I plugged the 02 sensors back in the bike started up no problem. I then removed the PCV and plugged everything back since theres no point if i have to have the O2 sensors plugged in anyways.

Any ideas to why it wont start with the O2 sensors removed, i looked at the PCV and everything looks good, plugged it back into the computer and it still held the MAP I had installed.

2009 BUELL 1125CR

 

[Theycallmecrash]

Never installed a PCV on the 1125, on the 1190 pretty straight forward. But regardless Id sell the PCV and get a tune on the stock ECM. Flash and go vroom vroom

 

[ztied]

some kits had the block offs that you plug into the o2 sensor plugs to give it a reading so they work, cant think of the exact name for them,

 

[lively13]

Where can I go to get a tune and roughly how much is it? (im a little on the broke side, specially after all these purchases)

 

[Theycallmecrash]

Www.xoptiinside.com can send you the tune and get you the software and hardware.
Sell the PCV try to get as close to even as you can

 

[lively13]

UPDATE: Reinstalled and it worked, put everything back together and it stopped working... I believe the starter switch is going out and i have gotten a reliable second opinion and they believe so too... so I temporarily installed a push start under my seat in case of emergency so i don't literally have too push start my bike (i know its not the best but it will do until I buy a new starter switch / kill switch)

THANKS!