O2 sensor wiring harness

[tokinbuller]

Hello again. While tinkering around the bike I have noticed a badly chaffed o2 wire, after where it plugs into from the actual sensor plug. If that makes sense? Basically buying a new sensor won't help because that side is good, it's the wires after the plug that are damaged. Looks like this wire gets wrapped into a larger bundle of wires that i assume goes to the ECM?
How do I go about fixing this?

 

[tokinbuller]

Anyone have advice?

 

[Silverrider]

Are you good with a soldering iron and shrink tubing and electrical tape and wire ? replace the old wires. If you can take apart the plug great, if not hard wire it.

 

[tokinbuller]

Never used a solder before an don't have one. I may have to look into the hard wire route. Would this require me to take a part the ECM to hard wire? Electrical is not my field sorry if I sound like a noob haha.
Also what kinda wire am I looking at here to run from the existing plug?
Is it bad juju to just cut out the damaged section and rewire that part?

 

[Silverrider]

just use the same gauge of wire.and do a R&R.

 

[AZmidget91]

I actually have a bag of these connectors if you need one.

 

[Silverrider]

There you go ^^^^^^^^Great Guy.

 

[tokinbuller]

PM Sent

 

[tokinbuller]

Just wanted to give a big shout out and a huge thanks to AZmidget91 for coming through with the o2 wire.
You rock dude, hopefully in some way shape or form I'll be able to repay the favor. Until then I owe you one bro :up:

 

[AZmidget91]

:up::up::up: