Oil/Tranny fluid change

[deviantspeed]

Refresh my memory from reading the manual from this afternoon, just want to be sure.

Oil - No stands, just level surface and on the kickstand.
Tranny - Drawing a blank but IIRC it said to put it on a stand (level which means about front and rear bike stands for me alone) and fill through the cover on the left side.

Thanks all!

 

[Theycallmecrash]

sounds good to me

 

[user_deleted]

yes sir.
check engine oil when bike has been sitting for at least an hour or more seems to give most accurate reading...and done on sidestand, level surface.
primary/trans checked with bike close to upright position as you can get it. you can fill the primary/trans either thru derby cover or smaller primary chain adjustment cover.

 

[g3stripes]

primary oil shud cover bottom of clutch plates bout 1/4 inch or so, to get oil bath. uprite

 

[deviantspeed]

Got it all, thanks all! WOW seems like a new bike... the tranny oil did not look good, so easy to change, seems like it was a bit neglected.

Reused the gasket on the cover, it's been fine ever since. Hah, actually had a torx snap on those bolts on the cover, had to run and get a new T27 the next day. PO or service used what appears to be permanent loctite. I just put a tiny dab of blue on those.