Ok so I recently bought a 07 buell blast from family friend knowing it wouldn't shift ,thought just need the shift pawl adjusted, but come to find out ,two of the pins being the detent plate are snapped off flush and shifting the bike by hand it will only go into 1st and neutral ,I know I'll need to open the main case ,but is there a way to fix the broken pins ?
pins behind detent plate broke off flush
- Thread starter Speed117
- Start date
Help Support Buellxb Forum:
Chicknstripn
Well-known member
Did a quick Google search for ya.
Check this out:
http://buellridersonline.com/forum/showthread.php?t=6827
The above thread talks about adjust the shift drum pins so that they don't stick out too far. Don't know how you would reverse that adjust meant.
Good luck
Check this out:
http://buellridersonline.com/forum/showthread.php?t=6827
The above thread talks about adjust the shift drum pins so that they don't stick out too far. Don't know how you would reverse that adjust meant.
Good luck
jetlee
Well-known member
If the pins are broken off, treat them as any broken bolt and drill/extract them. Replace with new pins and then be on your way.
No need to open the case.
No need to open the case.
Hey Speed117, There's no need to start a bunch of new threads when it's the same subject on the same bike:up: It will help everyone keep up to speed and give you better advise.
jetlee
Well-known member
Check out the parts manual at http://BuellMods.com and then go to most any Harley dealer and order by part number. Never mention "Buell" or they usually refuse service.
Aren't they just regular hardened roll-pins? I doubt Buell proprietary engineered that part. Take the old ones out and measure. I bet your local hardware store has some.
