please help with my buell 2009

[rkadlcek]

hi guys please help ... forgive my spelling .. I am from Czech Republic ... I have a 2009 Buell lightning xb 12 ss long motorcycle ride year ... no problems .. I have a race emc., ... kn filter ... and original exhaust who is set carved, according to instructions from youtube ... Everything was fine one day and the bike started to shoot into the exhaust ... I tried with tps reset, change plugs, change cable for plugs, clear filter .. recharge the battery to its maximum now has 13,8 V. .. I tried to make the diagnosis and He showed me the trouble codes 13,15,21,34 ... o2 sensor I replaced it with a new but still proves problematic on the 13th .. please help in the Czech Republic is not nobody who can help me you're my only hope

 

[Baruch_RR]

Can you connect it to an ECMspy?
There are some checkups that you can run to see what faults in the ECMspy

 

[100thwindow]

Are you saying the stock muffler is gutted? If so try finding someone here who has the maps for the set up you have. Hopefully you get it resolved. Gl

 

[rkadlcek]

in the Czech Republic is not nobody who could help me and my stim emc spy does not work with 08 + years it is a problem and do not know how to solve it .... and yes the exhaust is cutt off year, but everything worked without problems

 

[ich]

vehicle voltage problem

 

[rkadlcek]

i do not understand why the tension?? battery?

 

[sparky300]

Nope, you're right ECMspy has limited applications on 08+ bikes, you can use TunerPro though to do just about the same functions.

You say you're still getting a code 13? I would check the coil output and do a continuity test on the plug wires, sounds like you're misfiring on one or both cylinders and that is giving you an O2 sensor fault

 

[rkadlcek]

spark plugs and cables Replace I cleaned the spark plugs ... I do not know how to test the coil ... but it should be ok ... I think that will help me try exhaut race?? may not carved exhaust for race ecm

 

[sparky300]

You THINK the coil is OK? How do you know? Are the plugs wires fully seated on the plugs and coil? Sometimes they FEEL like they are seated but they're not making good contact. Make sure the coil is well grounded. I ran a separate coil ground back to the frame.

 

[rkadlcek]

deployed are ok .. and the coils .. and spark plugs .. I tried it today .. tomorrow I'll try grounding still on the reel ... but today I followed the service manual tried all the black cables that serve as ground and everything was ok

 

[rkadlcek]

hi me drive Buell worked well .. I have a filter on it CN race ecm and exhaust which is carved completely and throttle actuator for compensation .. Buell I ran well all year .. Now I started shooting from the exhaust, that I never had ... I tried to clean the spark plugs, cables to replace spark plugs, tighten connectors, according to the manual, I tried it with a multimeter grounded, clean the filter, replace the oxy sensor, replace the actuator for compensation, I checked the oil, I recharged the battery and measured 13.8 V, tomorrow I have borrowed the original race exhaust, and iridium spark plugs, then I do not know the year and ran day-to-day all the problems I do not know .. I zkošel and diagnostics via show-through pins and showed me the following as 13,15,21,34 thank you welcome any advice