Stator wire config help needed

[BuellRonin]

Long story short, used the Stator DIY...which helped out 100%. Thank you for the write up.

HD warranted my stator, but forgot to look at wires and mark. So now I have a new stator and forgot how they go back into the connector.

need a little help

cheers!

 

[d_adams]

3 yellow wires? Does not matter, it's 3 phase ac output to the regulator. Should be 16-20 volts per 1000 rpm or 32-40 volts ac at 2k rpm.

 

[BuellRonin]

D_adams - They are all black. Since I didn't have the new stator in hand I forgot to at my old stator. So I don't know how they go into the fastner.

 

[d_adams]

Still doesn't matter which pin/wire goes where, it's a 3 phase stator. As long as each wire from the stator (the 46 connector) matches up to a wire going to the regulator, you should be fine.

 

[BuellRonin]

can you post the second part of this manual. Thank you very much. Guess I don't have a correct shop manual

 

[BuellRonin]

Looks like wires need to correspond from the regulator to the stator. Thanks I think I can mark them from this diagram.