Throttle cable trouble....

[njdevils1990]

Well im putting the high bars back in because i couldnt get the shorter throttle cables to work without binding up and they wouldnt allow the throttle to snap back right away so i just got done routing the cables and everything is going smoothly and i go to put the bottom of the air box in and all of a sudden its not snapping back and is binding up somewhere but i dont know where or why, its VERRY frustrating and i want it fixed but dont know what to do, and im not taking it to the dealer for them to go charge me 100/hr for something that could be a simple fix. Im calling out of work today to get this done so any insight would be VERY appreciated!!!!!

 

[Stevenc150]

So it does fine with airbox off? As long as cable has been lubed not sure. Pics would help.

 

[buellybill44]

If you took the throttle setup apart on your bars make sure everything lined back up and put together straight.. I had a similar prob and it was a dumb mistake on my part but turned out to be my cable not being lined up properly. Good luck!

 

[njdevils1990]

I fixed it, the rubber seal that goes around the throttle bodies was rubbing against the linkage on the right side that connects the two throttle bodies causing it to move slowly and not open up all the way, I cut about 1/2 inch by 2in long of a piece off so everything works and still seals up and I'm just glad it's all over and done. Also if anyone wants a clubman bar an all the hardware pm me I'm selling it.