tps reset?

[ronmetzler]

is their a TPS Reset procedure for the CR like the XBs? if so, what is it?

 

[Stevenc150]

Exactly the same:


'08+ TPS Reset Procedure:

- Turn on the key.

- Set the kill switch to the run position.

- Don’t start the engine. Rotate the throttle from fully closed (gently forced closed) to fully open (gently held open), and then back again to closed (gently forced closed).

- Repeat 3 times. Hold each position (fully open, fully closed) for 1 full second.

- Turn the key off and on.

 

[boreas]

If you got the EBR ecm ,here's what I got from the instruction sheet

A)DDF13 race ECMs (2008 -2010):Two things need to be done after installation of this race ECM to make sure everything works properly:
1)Turn key on and make sure kill switch is on run.leave this way until step 6.
2)Do not start bike
3)Turn throttle to full open and hold about one second.
4)Release throttle completely so it snaps shut.Wait one second.
5)Repeat steps 3 and 4 (full throttle,hold and release) two more times
6)Turn key off for at least two seconds.
7)Then you can turn on and start.

2)IAC averaging re-set (IAC)-Idle Air Control

Start bike and let Idle for ten minutes.

 

[ronmetzler]

If you got the EBR ecm ,here's what I got from the instruction sheet

thanks. I ordered the EBR ECM. arriving tomorrow