TunerPro ADX Files

[dmulligan]

Can someone tell me the difference between the ADX files below? My goal is to get TunerPro RT V5 to work with my 2009 XB12Ss (ECM BUEYD). Since mine is a 2009, I'm assuming I use the DDFI_3 file but still curious as to the difference between these? Is the BUEYD_V5.adx file for pre 2008??

DDFI_3_2008-UP.204162932 (1).adx (from Xopti site)

BUEYD_V5.adx (from ECMSpy site for TunerPro V5)

I will figure this thing out at some point... Thanks

 

[xoptimizedrsx]

email sent...

Mine was the First where Gunters followed with added connection data verification matching firmware to the data file to link.

I have a selectable dashboard and History Table based on actual Injector fuel getting injected vs the fuel table. which is based on all correction of the sensors.
(you need to edit the values in the history table to fit your ecm values under edit adx/history tables)

Gunters has error codes and flags I didn't put in. You can blend either way to make a custom of the two putting in everything we both did and have the best of both. I honestly use each version depending on what I am doing.

You can also edit in a commands line to send the hex to clear codes and test functions even reset the tps. Which is for the 2007 XB and older. A command line to reset tps which lets the ecmps preform the reset. It's 100% safe that way. you just add a command in the ADX name it and set the hex code string to send the data. each string does a different function in the ecm.

 

[dmulligan]

Thanks again, Mike