Two questions??

[scruffman]

I just picked up a blast project and the carb. is off the intake manifold? what holds it on?? a rubber hose about one and a half inches around??

and then on the foot brake side the round timing cover?? is missing.. what is that? on the crank case?

thanks guys..

have a project in mind will post pics and ask questions as I go.. once again thanks..

 

[wolfo68]

the round cover is over the cam position sensor

the rubber hose is the intake boot.

not really sure what you actual questions are there. but I hope those are the right two

 

[wolfo68]

with the superboot you can get on ebay

 

[scruffman]

yeah.. thanks..
now where to purchase them?? the cam position sensor is completely gone wire are there though.. and the carb is hanging. that looks like a clamp on the carb? is it?

thank you..

 

[wolfo68]

that clamp is the super boot it holds the carb up there in place. I believe there was a blast cam cover on ebay earlier today. it might still be there

 

[scruffman]

I need the whole sensor.. that part is missing??

I'm on evilbay now searching frames and parts..

 

[wolfo68]

I don't see the sensor on there, you might have to talk to hd for that. or I can see if the xb ones are interchangeable

 

[scruffman]

see the round cover in the pic below the carb..
that's what's missing and the wire is cut. I saw in two different search's it's call two things? last night I found it as the cam shaft sensor? and this morning the ignition module?
[confused]

 

[wolfo68]

http://www.badweatherbikers.com/buell/messages/20164/328601.html

http://www.badweatherbikers.com/buell/messages/20164/189423.html?1317260005

a few guys doing part outs here

it's the cam position sensor or the ignition module. basically it tells the engine when to ignite in relation to where the cams/piston is