WTB: D&D exhaust

[acko71]

Wanna buy a D&D exhaust for my XB9r -03. Serious buyer. If you got one up for sale PM me...

//Acko71

 

[kab]

Just curious why your heart is so set on a d&d?

 

[anrkizm95]

because its an awesome pipe

 

[xtreme]

everyone is entitled to their own opinion.

 

[kab]

I never said anything was wrong with the d&d pipe, I was just simply asking why he wanted one.

 

[anrkizm95]

because they sound awesome.

 

[acko71]

Just want one cause " sounds great" "rare over in sweden" Had a D&D on my last bike and loved it, thats why....

 

[onelogue]

I'll very that yes, D&D is the closest sound to Harley. Only pipe that I could hear the cams on Deceleration. Loved the sound but it hurt my ears.

 

[forerunner]

+1 on the sound. I absolutely love mine and haven't found anything else like it. Not everyone's cup of tea but if it is and gets in your blood, you've had it.

I've read criticism about loss of low and high end power in exchange of a strong middle which is fine by me as that's where I spend most of my time. I'm not after absolute power and doubt my meager skills could detect a loss(or gain) of a few ponies.

YMMV,
Nels

 

[MotoX6]

Wish someone would sell theirs, I want one too! I have a brand new aluminum jardine and a stock exhaust I'd trade + cash for one!

 

[BuddhaBuell]

sorry this one is not for sale, it has had its mounting tabs cut off and all excess ground off for a clean naked no chin fairing look

 

[onelogue]

Wish someone would sell theirs, I want one too! I have a brand new aluminum jardine and a stock exhaust I'd trade + cash for one!

Where was all this interest when I sold 2 last year and only 2 people PM'd me for each. I sold them at a great deal too.

 

[acko71]

Bump

 

[d_adams]

Similar, but in all 304 stainless?

 

[MotoX6]

What's that cost ^^^

 

[kab]

That cost enough to be eating ramen noodles for a while. Why don't you guys just buy one brand new?

 

[oh9bolt]

Keda Design

 

[d_adams]

As pictured, $650. With either straight cut or slash cut outlets, $600. I built that one with 2.5" internals for an xb12. I'd recommend using 2" for an xb9 though. I have one here (the bike) that I'll be doing some testing on in the next few weeks. I'll do both the 2.5" and 2" setup. It's got a jardine on it now, so that's what I'll have to use as a baseline unless I come up with a stock xb9 exhaust.

 

[MotoX6]

woah ya thats a bit spendy! hey i have a stock xb9 exhaust if you need one, its pretty clean ^^

 

[d_adams]

Spendy, maybe, but it is hand made to spec. I don't know that it's any better for performance than a d&d since I don't have a baseline to compare it with, but it didn't do too awful bad on the xb12 I tested with. It's also all 304 stainless instead of mild steel. When they're polished, they don't rust and wipe down pretty quick to get it cleaned again.