Dae

outthere · Apr 28, 2019

Can't wait to see how this works.

dantroop · Apr 30, 2019

Nice Welds! Can't wait to see it in place.

outthere · May 1, 2019

This will end up being my Thunderhill exhaust unless it's quiet. Do they come bare?

outthere · May 2, 2019

shipped today.

outthere · May 21, 2019

Does the exhaust hangar look right? He sent a spacer with it but it's not being used.

ocgreenmachine · May 21, 2019

Looks right, but make sure you don't overtighten the T-Clamp. I had breakages due to my mistake of overtightening the clamp. I believe he recommends 110-120 in/lbs on those t-clamps.

outthere · May 21, 2019

Thanks for that I'll double check .

outthere · Jun 18, 2019

Deans exhaust performed well at Thunderhill East. Quick to rev off the bottom if not a bit flat up top (The Drummer will bounce the limiter if you let it). Could be a tuning issue. This will be my pipe of choice for Sonoma.

d_adams · Jun 18, 2019

This is the factory torque spec.

Also, the spacer included depends on how it's mounted. Some require it, others don't. It's dependant on the header mounting and how it's lined up. Most of the time the spacer is used.

outthere · Jun 18, 2019

I'm using the spacer

Dae

Help Support Buellxb Forum:

outthere

Well-known member

Attachments

dantroop

Well-known member

outthere

Well-known member

outthere

Well-known member

outthere

Well-known member

Attachments

ocgreenmachine

Well-known member

outthere

Well-known member

outthere

Well-known member

d_adams

Super Moderator

outthere

Well-known member

Similar threads

Latest posts