I’m upgrading my XB12R with the ZTL2 caliper. I purchased a new master cylinder but it didn’t come with the clamping end cap. Does anyone have a spare they are willing to part with? Or I can make one but would need pictures of It installed with brake reservoir. Thank you in advance for the help.
Need parts or pictures
- Thread starter 45vtwin
- Start date
Help Support Buellxb Forum:
34nineteen
Well-known member
Its the same as the stock one. You can also order a replacement for less than $10 from Harley.
Cooter
Well-known member
I have an extra one but it would be easier to get new for that price. Besides any clamp for 7/8" bars should work, just make sure the bolts are not off-set like an old Honda.
Sorry for the omission, I am replacing the XB12R master cylinder with the one from an EBR. The XB’ screws for clamp are offset and the EBR master cylinder are not and didn’t come with the clamp. I’ll try to view it off the parts manual from Buellmods
34nineteen
Well-known member
Awesome, you figured it out! Looks like both parts are available for less than $40.
mike lowary
Well-known member
I used a clamp from PSR on the master cylinder and a universal billet 7/8 clamp for the reservoir.
34nineteen
Well-known member
"Universal billet"??? its like I dont even know you anymore.
mike lowary
Well-known member
It was $15!! Couldn’t say no
34nineteen
Well-known member
Sorry pal, you set the bar way too high and now this??? Its like seeing Gordon Ramsay eating at McDonalds.
Mike, thanks for the pic. But I don’t have the room on a XB12R for universal billet bracket.
34ninteen, where did you Source those part numbers from. I’ve looked at LP eBay store and didn’t find them. I did find a Rx clamp without post for mounting mirror and the Rx brackett for
Mounting the reservoir.
34ninteen, where did you Source those part numbers from. I’ve looked at LP eBay store and didn’t find them. I did find a Rx clamp without post for mounting mirror and the Rx brackett for
Mounting the reservoir.
