Revision moto exhaust

Buellxb Forum

Help Support Buellxb Forum:

Hypefxx

Well-known member
Joined
Sep 20, 2022
Messages
82
Just got the revision Moto in xb-sg model.

I have a 2009 xb12xt and figure out why the bolts don’t line up. Especially on the backside. I wonder if this is defective or it’s not made for this. Can anybody chime in. I did send them an email and they haven’t gotten back. Took them two weeks to send it to me
And now I’m frustrated about the fitment.

F3ADC458-B145-425C-B9D4-DFA1CDD093B3.jpg
C1662F08-C2EE-44E7-8087-7974A7FF684F.jpgF5907B3E-4BBC-4719-AE0A-8AE6580D7C57.jpg
 
Sounds like it wasnt designed using Pluton.

Also seems like instructions weren't read, but thats not your fault. Probably none available, but if Pluton was used, this wouldnt be an issue.

Since Pluton wasnt used, a quick google search of rev-mo muffler installations pictures should reveal the likely issue.


Are you going to wrap the muffler with the exhaust wrap also?
 
Last edited:
Their website wasn’t so detail. But yah could have been my fault. I only wrapped the header because it was ugly with dark spots. Not sure if there going to take the refund otherwise I would have to build some type of mounts for it.
 
Looks like I gotta remove the oil line to get the oem muffler brackets off. Revmo instructions never even mentioned it. Pretty annoying
 
Got the exhaust on and rode it today. 2ACDB4E5-7D62-46FD-9445-9AC551BB443A.jpg9929C351-0FD1-4CC7-9067-CC7F445238CA.jpg
The cold start is loud and deep. I’m sure my neighbors hate it. It mellows down after a minute. Test drive was pretty nice. Strong midrange to upper torque. Decel pops are still there even with the tune file and the tps reset. Just a little less than when I had the gutted stock muffler.
 
The gaiters just got squished down . I was going through some whoops. It’s a xb12xt
 

Latest posts

Back
Top