I'm new to the forum as I've just purchased a 2008 1125R. Nice bike I will say.
I had the airbox cover off today and noticed the Bosch MAP sensor tucked in a bracket located to the rear of the airbox.
Upon observation I noticed it has a nipple and which look hose would have attached ed like a neoprene o-ring which would normally tell me that a hose is dis-connected. After about an hour searching for a hose or just a connection point where the hose would possibly attach, I gave up.
My bike idles fine but upon decel, it doesnt back down like you'd expect. It still pulls around 3k RPM's until clutch is activated, which to me could be a common symptom of a failing MAP sensor, or one that isn't connected.
I believe it has OEM ECM still in it.
Could someone steer me in a postive direction about a possible hose that would connect to MAP sensor.
Thanks
Zeus
I had the airbox cover off today and noticed the Bosch MAP sensor tucked in a bracket located to the rear of the airbox.
Upon observation I noticed it has a nipple and which look hose would have attached ed like a neoprene o-ring which would normally tell me that a hose is dis-connected. After about an hour searching for a hose or just a connection point where the hose would possibly attach, I gave up.
My bike idles fine but upon decel, it doesnt back down like you'd expect. It still pulls around 3k RPM's until clutch is activated, which to me could be a common symptom of a failing MAP sensor, or one that isn't connected.
I believe it has OEM ECM still in it.
Could someone steer me in a postive direction about a possible hose that would connect to MAP sensor.
Thanks
Zeus