today i swapped out the stockers for some aftermarkets. front ones replaced no problem, flashed just right. although the males on the new ones didn't plug into the female stock with a perfect fit (too skinny), so taped them together.
then i go to replace the rear sets. not enough wire either side to reach the females. i cut off the stock males and connected them to the rear wires to extend them, and connected everything perfect. then i test them out and whichever side i blink stay solid and it makes a wierd noise, any ideas?
and by the way, how the heck do u take the bulb out of the tailight?
then i go to replace the rear sets. not enough wire either side to reach the females. i cut off the stock males and connected them to the rear wires to extend them, and connected everything perfect. then i test them out and whichever side i blink stay solid and it makes a wierd noise, any ideas?
and by the way, how the heck do u take the bulb out of the tailight?
