axle spacer dimensions all Buells

[cvc]

Okay we all are aware of the over torqued bearing spacer issue grenading wheel bearings but nowhere can I find the correct dimensions to use my micrometer to check them.

Does any one have this info or new unmolested spacers they are willing to measure and post here?

tuber:
front length
I.D.
O.D.

rear length
I.D.
O.D.

XB:
front length
I.D.
O.D.

XB: (2brg)
rear length 202.67mm
I.D. 36.79mm
O.D. 31.34mm (thanks Tpehak)

XB: (3brg)
rear length
I.D.
O.D.

Blast:
front length
I.D.
O.D.


rear length
I.D.
O.D.

 

[cvc]

Bump. I can’t believe no one has bearing spacers or dimensions

 

[cvc]

Blast rear:
length 68.2mm/2.677in
ID 17.98mm/.708in
OD 22.18mm/.875in


2009 XB front

Length 4.250 inches 108 mm long

ID.1.032 inches 26.21 mm.
OD.1.250 inches 31.75 mm.

 

[cvc]

blast front was used but bearings were good

 

[cvc]

Still looking for the rest of the measurements

 

[andrewnel]

2008 XT (2 Bearing rear wheel)

front: Length - 4.25in 108mm
OD - 1.25in 31.9mm
ID - 1.02in 25.9

Rear: Length - 7.95in 202mm
OD - 1.45in 36.8mm
ID - 1.21in 30.9mm

My micrometer only reads up to 10ths. I will see if I can get a more accurate measurement from a better one and update if I do.

 

[Cooter]

Thanks for posting those. I have some still in the bag I can measure when I get home to confirm.

If someone takes these measurements with the intention to make their own, just remember it is there to support the inner wheel bearing races together against the torque of the axle, before the outer races seat against the wheel and side load the balls in the race. So it is an 'at least' measurement that has to be square (cut on a lathe, not a shop saw), and 7075 aluminum is fine.

 

[cvc]

This list is still short no one have a 3 bearing spacer?

 

[Rays]

3 Bearing spacer (measured from a new 3 bearing wheel kit that hasn't been assembled)

Length - 6.735" - 171.07mm

OD - 1.456" - 36.98mm
ID - 1.221" - 31.03mm

 

[cvc]

Thanks to Rays