Buell 1125CR High bars

[Cosworth]

Selling a set of 1125CR highbars - read below

These were on a wrecked 1125CR I just purchased, but I measured the bars on a flat surface and they do not appear to be tweaked at all. The entire steering head busted off before hurting the bars.
But the bars do have some rash on the right side but shouldn't hurt anything.

Not sure what a fair price is for them, but thinking $30+shipping


Also if you are looking for anything else I will be parting most of the bike out (parts that arent damaged)
It is a 2009 1125CR

 

[Global Eyes]

I'd be interested in the flyscreen.

 

[Cosworth]

flyscreen was a total loss sorry.

 

[Global Eyes]

Thanks anyways.

 

[Cherry_Bomb]

Any pics of the wrecked bike? Maybe interested in some parts. Other than the windscreen, what condition are the fairings in?

 

[UMDterp13]

Front caliper? $?

 

[Cosworth]

Front caliper was the main reason I purchased the bike, its going on my XB9SX sorry.

Im going to start another thread for parts and try to list whats for sale, just started dismantling the bike last night.

 

[UMDterp13]

Is this the bike out of Mo?

Mirrors $?

 

[Cosworth]

Bike came out of Oklahoma.
Never got the mirrors but looking at whats left of the perches they are trash. Ill look in my stash though i may have a set still.
Frame is bad but still carries a clean title.
1 fork leg is good other is bent but hardware is good (black/red cap)
upper triple (CR only has some nicks but is ok), lower is ok but stem is bent
Rear swingarm is undamaged
Has stock ECM on the bike, havent plugged it in to check for tuning of any sort yet.

This is what it looked like when it got to me, engine was drained of oil so no damage laying on its side.

 

[UMDterp13]

Oh I was assuming it was the bike from your first picture.

 

[Cosworth]

Yea I thought about that after I posted, I was just trying to show the difference between clubmans and highbars.
There are quite a few use full parts on the bike, mainly wanted the ZTL2 caliper for myself.


The bike pictured is my 1125CR I drove to northern Arkansas for it. Bought it off a forum member.

 

[Cherry_Bomb]

Well let me know what condition the fairings are in when u have time

 

[Cosworth]

Ill take a closer look this afternoon, tail fairing is no good. 1 radiator pod is for sure scrapped up badly, the other side im not sure of. The tank cover has scrapes nics etc

 

[Cosworth]

So far,

Pastics are all scrapped up, no good unless you want them to try an idea or something

-fans are good
-wiring harness is good
-top triple is good but has a minor scrape
-left radiator is good (right is smashed)
-1125CR ECU is good

If you need various fasteners, etc let me know.

 

[Global Eyes]

Gauge cluster?

 

[Cosworth]

Gauge cluster was lost at crash site. Sorry man, seems like everything you've wanted is busted or missing.

The story I was told is a lady pulled out infront of this rider and he could not get around because of traffic and ran into the back of the ladies car. He and the bike both went over the car when landing the front end of the bike busted off at the tank. Hes ok but bike was non-rebuildable

 

[Shawns]

Stator and Rotor?

 

[Chazaag]

How much for the key set - ignition, gas cap, seat lock?

 

[Cosworth]

Sorry havent been on in awhile. I actually have to extract the key from the seat and remake it so that they will all match. I dont think it'll be a problem to do so just havent yet (shipper broke the key)

On a side note I think im going to let the ZTL2 brake go, it has a minor scrape on it that I may just touch up with red caliper paint.


Engine is for sale, im not sure of the mileage but the title was transfered at 6500 miles so it has MINIMUM 6500 miles.

 

[Zhen13]

Hi, I am interested in the CR high bars if you still have them