buell 2009 bad fuction cycle

Buellxb Forum

Help Support Buellxb Forum:

rkadlcek

Well-known member
Joined
Jun 20, 2011
Messages
91
Ahoj, já jsem z Česká republika a dostal jsem radu od nás nebo jeden HD potřebuji poradit. Motorbike me shooting into the exhaust into the airbox. Motorka mě střílet do výfuku do airbox. The engine stops or places to ride him not to approach it is 2009 and I can not mechanically reset TPS because it has controlled electronically tailpipe is carved and ECM mam race unfortunately I do not know if it still does not return original ECM that it helped and I've already bought the original tailpipe strsiho of year but it too did not help I already desperate and do not know what I was thinking if he can not play ECMspy help but can not find any compatible for the year 2009 or maps, and yet I wanted to ask someone if we do not know to do is reset the TPS and somehow I heard otherwise of the meters in 2009, resulting otcit motorcycle gas motorcycle, and then turn on after 20 seconds of adjustable sam please consult any information is good to me
 
2009 models have an easy tps reset,

- Turn on the key.

- Set the kill switch to the run position.

- Don’t start the engine. Rotate the throttle from fully closed (gently forced closed) to fully open (gently held open), and then back again to closed (gently forced closed).

- Repeat 3 times. Hold each position (fully open, fully closed) for 1 full second.

- Turn the key off and on.

it's in the firebolt section so I'm assuming it's an xb r


edit: procedure thanks to a post I read from anrkizm95
 
Hello guys, I tried to reset the TPS you advise me on the Buell 2009, but did not help me :-( I checked it in EMCspy and the value is still 9.4. Even after many attempts, nothing has changed, unfortunately I only race mmc I was taken back to the original exhaust, tried it again and reset it does not help, the value is still 9.4. I do not know the same time, no advice and I do not know if I should buy the original EMC. Remap does not work, I can not find anywhere at the 2009 program or maps. I'm clueless , the season is gone and the bike is still in the garage. please advice. you still send instructions by which I restarted the TPS (2009 Models have an easy TPS reset

- Turn on the key.

- Set the kill switch to the run position.

- Do not start the engine. Rotate the throttle from Fully closed (Gently forced closed) that the full open (Gently held open), and then back again it closed (Gently forced closed).

- Repeat 3 times. Hold each loop position (full open, Fully closed) for 1 full second.

- Turn the key off and on. )
 
Please, for the love of god, confine yourself to a single thread. I am going to delete your other threads and keep just this one.

The original ECMSpy does not work for 08+ bikes. If you already did a remap using this old software, you have screwed up your ECM.
 
That's because ECMSpy is incapable of resetting your 2008+ TPS.

If your problem is mechanical, tuning will not help you. If going back to stock produced the same problems with your bike, then it is unlikely that the race ECM or exhaust is the issue.
 
Please PLEASE PLEASE stop posting more threads. You only need one. If you want it at the top of the list, just bump it by typing something and posting.
 
Yes thank you dave, He doesn't need ECM Spy to reset the TPS. The Key Turn Method works good on the Newer Buells. The plugs could be Shorted due to to much fuel.*rkadlcek, Take out the Spark plugs and check them.Be careful when removing the Spark Plugs and Reinstalling them.This takes a little time to do. You may need a manual to help you. There is some manuals at the top of the page. Some of the information still works for many areas of the Buell bikes. (BUT) the TPS reset on the 2008/2009/2010 Bikes are Completely different. Go by the Procedure here above,on this post, for Resetting the Throttle Position Sensor, Your ECM could be Corrupted due to hooking up ECM SPY.One Thing at a time.Check all you have done on the Bike.*Jimi
 
Back
Top