buell fuel pump puller

[deadxb]

part # B-45657 from what i have found out it only costs $60.00 through Harley from kent moore tools ... the thing is they say it will take 2-3 weeks b4 i will have it . wtf'f with that ??

 

[bobaganoosh]

you dont need it i pulled mine without it. just work it out with a screwdriver or something

 

[Rays]

+1 on using a screwdriver. If you put a short bolt on the threaded puller hole and use something as a small fulcrom point on the frame (I used a 1/4" socket sitting on a rag to avoid marking the frame) a flat-bladed screwdriver will work just fine to lever on the bolt-head.
There are probably many ways to do it but that is one that doesn't risk marking the pump or the frame.

 

[07Bolt]

made one from scrap metal; its curved instead of squared like the kent one. drilled a hole in the middle and came out in 30 sec.

 

[TML]

What size bolt fits in the puller hole?

 

[buellxb9rs]

I have one I made and I didn't even use it

 

[rchuff]

I made one to and have used it a couple of times

 

[thrstrmech]

try jim's usa...they may not have the tool you're looking for, but they have lots of others tools for Buell motorcycles, catalogs are pdf format, tools start on tab 20

 

[snrusnak]

I used a screwdriver, it wasn't that hard to get out.

 

[TML]

What size is the bolt that fits in the fuel pump threads????

 

[TML]

Does the swingarm on a xb12r really have to be taken off to pull the fuel pump? Or can you just undo bolt the bottom of the shock and let the swingarm drop a bit and get it out?

 

[snrusnak]

You should not have to remove the swingarm. Just unbolt the shock from the swingarm. It is a PITA though.

Here:

http://www.buellxb.com/Buell-XB-For...el-pump-fix.-Cheaper-than-replacement-from-HD

 

[gater]

has anyone used a fuel pump from a Ford Mustang V-6

 

[snrusnak]

Click the link in the post above yours...

 

[MrFantastic22]

Used a screw driver, worked like a champ.

 

[nicholas900]

What size bolt fits in the puller hole?

1/4-20

When I pulled mine I just screwed in a bolt, then wiggled and pulled. It came out easy. I did have my swing arm off though so I had a straight pull on the bolt.

A screwdriver should do fine.

 

[X B]

part # B-45657 from what i have found out it only costs $60.00 through Harley from kent moore tools ... the thing is they say it will take 2-3 weeks b4 i will have it . wtf'f with that ??

Go to local Home Depot and buy a 1/4-20 x 1.5" long bolt, a washer, a piece of thick aluminum bar, some tape and make your own tool

 

[user_deleted]

Go to local Home Depot and buy a 1/4-20 x 1.5" long bolt, a washer, a piece of thick aluminum bar, some tape and make your own tool

very cute TEABAG. you posted that exact pic on 10-9-2016 under your prior board name TPEHAK. how did you snake your way back onto this board?

 

[Outlaw]

I knew it smelled like tea foam

 

[Outlaw]

Good call John.