Buell tools

[sfbmx88]

So Ive been scouring the internet for the passed day and have barely found any tools to remove the clutch on my 2008 xb9sx. Anyone know where I can get the following tools? Even alternative, non-harley/buell tools will do!

-clutch spring compressor(hd-38515-a)
-clutch spring forcing screw(hd-38515-91)
-sprocket locking link(hd-38362)
-clutch shell bearing remover/installer(hd-38362)

I found this, but Im not sure if it will work...
http://www.motionpro.com/motorcycle/partno/08-0137/

I just need to replace the clutch shell needle bearing, but I would like to have the proper tools. Any help would be greatly appreciated! Thanks in advance!

 

[squidbuellie]

http://www.americansportbike.com/

 

[Hammel13]

heres one.

Clutch Compression Tool

They also have it as a kit with the clutch plates if you dont have any yet.

 

[lexhere27]

I got everything I need from americansportbik.com

 

[Iamarchangel]

So Ive been scouring the internet for the passed day and have barely found any tools to remove the clutch on my 2008 xb9sx.  Anyone know where I can get the following tools?  Even alternative, non-harley/buell tools will do!

If you took a whole day and didn't find americansportbike.com, you must be easily distracted by the whole net thing.

Focus.

 

[sfbmx88]

All my searches related to just the part numbers on the tools, so I never got around to americansportbike...
Thanks though guys! Now I just need to find a clutch shell bearing remover/installer(hd-38362). Went down to the dealer today to get the parts(bearing is on back order) and also asked about tools. Parts guy told me that the tools are generally unavailable to the public but tried looking up the bearing tool. The price is listed at just about $400. Has anybody replaced the clutch shell needle bearing before? If so, did you use this tool specifically? If not, what did you end up using?

 

[RT Performance]

Wow great link Hummel 180 tools and all with an extra disk.

 

[sfbmx88]

Anybody have suggestions for the bearing installer/remover? Should I just use a socket to install the bearing???