Clutch weep fix and new springs

[Beau]

I just ordered the new EBR clutch actuator and higher rate clutch springs. I figured I'd throw in the beefier springs while I'm in the area sand they were relatively cheap. Has anybody used those springs before? Thoughts? Any advice or tips before I start? I watched a video about it on YouTube to prepare.

 

[Kruizen]

Unless your doing drag starts you don't need them. Left hand is going to get a work out.

I ended up alternating every other one -stock, Barnett,stock, Barnett etc. to lighten up the pull a little bit.

 

[P3_techman]

Agreed. Mine is stiff enough already, I couldn't imagine doing that to myself. Think of being in traffic going from red light to red light. Doesn't sound fun to me. Everything works perfectly well with the EBR slave cylinder alone in my opinion.

Do what you will, but my money is on you swapping them back out for stock later and risking damaging your paint again. Just my two cents.