D&D exhaust installation problem...

[xb12chick]

I have an 09 xb12scg and I just put on a new D&D Slip-On exhaust. I have two problems, the belly pan doesn't fit onto the new D&D mounting brackets and the second problem is, after warming up the bike with the new exhaust I noticed the headers were bright red hot. Can anyone give me any advice?

 

[lunatic]

headers red hot would be bike is running to lean (correct me if i'm wrong) you would need to get a piggy back system or re flash ecm. belly pan might have to do with out or modify.

 

[TMC]

I had the same problem with my chin fairing. I just kinda forced mine on starting from the front mount working my way back

 

[gbalias]

theres no good piggy back for our bikes.

have to tune the ECM. or go for a ride for a while between 2500-4000RPM and see if it helps it out while the ECM learns the new airflow. keep in mind, itll only correct so much.

 

[xb12chick]

Thanks everyone! I was able to get the belly pan mounted, finally. I disconnected the battery and then hooked it back up. I was told that it might re-set the computer. It seemed to work the headers haven't been red hot so far. All is good, sounds killer