ECMSpy issue

[ksva]

Hi all,

I have recently installed a new drummer exhaust for my 2007 XB9R. Over the weekend I attempted to flash the EBR Race fuel maps.

I used the race eeprom from this site: https://sites.google.com/site/ecmspy/xb9/2007 (2007XB9Race.txt)

I loaded up two instances of ECMSpy, loaded my stock EEPROM into one, the race EEPROM into the other. I highlighted the front and rear race fuel tables, pasted them into the corresponding locations on my stock fuel maps, then burnt in the new map. I did not touch anything in the timing tables.

The new map runs absolutely terrible, the bike won't rev past 4k in gear. I went back to stock. Stock also runs terrible now. I have a feeling something went very, very wrong while copying over the fuel tables, or while burning the new fuel maps, or even while saving my stock EEPROM before I got started.

Could someone take a look at these maps and tell me if this looks okay for a stock 2007 XB9R? I don't know enough to tell if this is f* up, but it sure does seem like it.

http://imgur.com/a/9ZvOz

 

[EricZ]

Your timing maps are majorly screwed up.

 

[EricZ]

Did you save your stock EEPROM before flashing the ECM? You need to reflash the entire ECM with the stock EEPROM and start over. Don't copy/paste. Change the numbers by hand to ensure they are going in the correct cells.

 

[ksva]

Unbelievable.. I feel so dumb. I explicitly remember saving the stock eeprom, the screenshots I posted are from my 'stock.txt' eeprom file. I'm guessing I somehow screwed that up as well, or possibly overwrote it.

long sigh....

Would you recommend flashing the following tables?
http://imgur.com/a/sVEs5

These are from the stock EEPROM found here:
https://sites.google.com/site/ecmspy/xb9/2007 (2007XB9Stock.txt)

If these values do not look right either, then I am pretty much stuck with what I have unless someone can post a stock 2007 XB9R EEPROM file. Anyone happen to have one?

 

[EricZ]

With the messed up ECM you have now, you should flash the ENTIRE EEPROM and not just the tables. If your ECM is from a 2007 XB9R then the 2007XB9Stock.txt should be good to use. You will also need to reset the TPS after you flash the EEPROM.

 

[ksva]

Alright, I'll give it a try. Thank you for your patience and help.

 

[EricZ]

 

[ksva]

I just got done flashing the downloaded stock EEPROM back on, I cannot thank you enough. It worked flawlessly, I slammed through the entire RPM range and found no issues. Thanks again!