• You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will see less advertisements, have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!

    If you have any problems with the registration process or your account login, please contact us.

Fault Code 53, ROM Failure

Buellxb Forum

Help Support Buellxb Forum:

mackdogman

Active member
Joined
Oct 3, 2011
Messages
30
I got a blink code of my dash & I am getting a 53 flash code, looked it up on the manual & it states ROM Failure. Bike seems to run fine with no power loss just wondering if anyone has ran into this code before?
 
From what I understand working on trucks the ROM stands for(Random O Memory), this would be the factory settings that cant be changed. I am trying to hook up to it with my laptop but I am in the process of trying to make a com adapter. Has anyone made their own. I just need to figure out were each wire goes from the Deutch plug going into the usb or serial end. Any ideas or some schematics showing were they would go?
11546_20111017052000_L.jpg
 
Xoptiinside.com has a wiring diagram showing where they go as well as selling all involved components if you wish to purchase.
 
I pulled my front fairing off to just check connections & found my ECM had "Race Only" stamped on it. My question (prob a dumb one) is does a stock or factory ECM have this stamped on it? If not could this possibly be my fault code 5-3 ECM Rom Failure?
11546_20111017085152_L.jpg
 
stock no,factory race yes also the ebr ecms.the codes for stock ecm and race/ebr are the same
 


Write your reply...
Back
Top