How to shut off Active Muffler Control with Tunerpro?

[PonyXB12]

I want to clear the check engine code and shut off the Active Muffler Control on my 09 xb12. I have tunerpro hooked up and going ( I think... I havent tried to burn an eprom yet tho)

the FLAG that says enable AMC right now is unchecked for some reason, I'm not sure why because it is def enabled on my bike, so I dont know if I just have to check the box and re-burn it or what? But it doesnt make sense to check the Enable box to disable it.

 

[PonyXB12]

All right figured it out... FLAGS- ERROR MASK BYTE 4.... there are four of them.. AMC stuck open,closed,short to ground, short to voltage. Go in and uncheck all four.. Save that. Burn it back VIA ECMREAD and check engine light will be off.

 

[Stevenc150]

[up]

 

[PonyXB12]

RE-POST From another thread...Good stuff for anyone that was lost like I was.



Ok new data on how to.

If a person beeeeeeeggggggggs hard enough you get answers.

Revision on how to If in doubt and you have good links ask for help. So I did. got basic info where I figured it out. now I pass it on.


tools needed

rs232/ttl cable I sell these same as old ecmspy cable.


1999 to 2010 bikes
Downloads Needed

1. Tunerpro basic
2. Ecmread
3. Mono runtime
4. Fetched data from bike
5. Matching XDF file to ecm Firmware


Now the easy part done this way. No converting needed according to Gunter on xpr to bin.

* Open Tunerpro
* load your xdf file
* go to the file on the top click it.
* Click open bin
* go to the lower screen on the right click the file type drop down arrow. select all file types.
* now go to your eeprom folder in the Ecmread program select the xpr file you like(want to load to tunerpro). It now opens in Tunerpro as a xpr file.
* make your changes as you wish and save. (rename it)
* save in the eeprom folder in Ecmread.


Now to Burn

1. click burn
2. navigate to the folder or location you just placed this new file from Tunerpro in.
3. read and check it a few times.
4. highlight it to select new file
5. Make sure you selected correct file.(read write does not care of firmware type) wrong firmware and you get issues)
6. select file now lower right of screen.
7. its now burning to the bike.

Done!

pretty simple that way huh? A fancy ecmspy!!! whoot whoot

ok I added data and streched his one sentence out a lot.
__________________
Xoptiinside.com

 

[PonyXB12]

THIS IS IMPORTANT AND WONT LET YOU RE-BURN IF NOT DONE RIGHT.........

click save bin as in the file tab.
change save file type to (*.*)
name the file with a .xpr
save to ecmread folder.

guess that wasn't clear

It will save as .xpr this way.

 

[PonyXB12]

BIG THANKS to Xopti and Octo