License plate mount ?

[CrazyTexan]

How has everyone been mounting their plates under the passenger seat of their bike? Modify the factory bracket?? Just looking for ideas, almost done with my S/R conversion and paint job.

 

[anrkizm95]

http://www.buellxb.com/Buell-XB-Forum/Buell-Firebolt-XB12-XB9/license-plate-under-the-tail

 

[CrazyTexan]

thankyou, I was thinking using the stock bracket just not sure about punching additional holes in the plastic. But i'll work with this. Thanks again.

 

[g3STRIKES]

i just drilled matching holes thru bottom of tail section

 

[CrazyTexan]

g3STRIKES, I thinking about this very same thing, but not sure how much i'd get screwed around with by the local sherrifs. Can you even see your plate from behind if you were looking at it in a car? I cut and bent my stock bracket and was looking at putting it back further under the battery area but where yours is mounted is easier access. I'll figure it out tomorrow when i'm working on it. Thanks for the Pic, and cool plate sticker.

 

[g3STRIKES]

u can see it fine,the law around here doesnt bother u for silly reasons like that unless u ask for it!mine isnt even lit and been like that forever and i ride alot. hope it works for u.

 

[g3STRIKES]

u can bend it out a bit if u like n u cud use led bolts yo mount it. thanks !!!

 

[jakestolar]

Dunno if you can see it well, but the bolts that hold in the plate have LED's in them to light up the plate at night. IMO it is a really clean set up

 

[CrazyTexan]

Thanks. Got it all taken care of. Just wating on the plastics to dry and polish them up!

 

[TXgold]

you should get this i just ordered one its sixk i will post pics once its on
http://www.trydeal.com/