Need ideas and input.

[kyle_dewald]

I;ve changed my mind about the rear turn signals on the bike. I want to take the undertail and cut a design out on either side (underneath) and put mesh in, first to help disipate heat and place the leds for the turn signals in there. My first though was some kind of buell logo or wording or something, other thought was to cut out a triangle. As in a long triangle that is not very tall that will run down the bottom on either side. That way it will give it a directional pattern for the turn signals and then maybe have buell across the center.

What do you think? Does anyone have a better look on it or better design?

 

[klauder88]

The pegasus would be a sick idea

 

[kyle_dewald]

I was thinging about that too, I have the Pegasus down both sides of the bike on the frame. I'm trying to get as may ideas as I can and make the decision on the best looking one. As far as I know, no one has done this so it will be extremly badass looking and somthing new and also functional for many reasons.

 

[Midnight82]

The only issue I could see with you cutting your undertail and putting mesh in is that you'll get crud sprayed back into your undertail from your real wheel.

Just my thought.

 

[kyle_dewald]

I've thought about that too, I'm leaving the rear fender on it, but on the inside of the tail I will come up with something to stop the crude and rain from building up or destroying anything. I will have to put some kind of barrier in there

 

[klauder88]

you could just do the wings you know? that could be cool too

 

[Hammel13]

you could have two pegasus's butting heads and then use the wings as the directional pointers

 

[klauder88]

I agree with hammel, that would be awesome

 

[SMDUB1]

Hammel13- you may have just inspired me..

 

[Hammel13]

give it a shot see if you can pull it off