Need Passenger Peg Measurement

[gobsoftorque89]

Hi All,

I was wondering if someone could give me the drop dimensions for the passenger pegs. I'm going to fabricate my own mounts considering they're a pain to get a hold of and pricey. If someone could give me the vertical distance from the most rear mounting bolt/hole on the subframe along with the horizontal distance. So basically x and y position of the peg itself to the rear mounting bolt. A diagonal distance from peg to mounting bolt would be good too just to check my trig.

Anyone know the thread size for that bolt as well.

 

[gobsoftorque89]

thanks in advance, gotta start getting some girls on the back

 

[oldblue]

This is what is looks like on my bolt. I have 11in measured straight back from where the heel guard is mounted to the point where the passenger footrest is. Its hard to get a measure of straight drop but from the most rear mount point it is 8 1/4 in diagonal to the peg and from the furthest most is 9 1/4. These are just rough measurements but I hope it helps

 

[gobsoftorque89]

Thanks ,I think that will work fine.

How about about how far they stick out to the sides to clear the swing arm?
I'm trying to find some pics on here for ref. i think i remember a good one in the led/pass peg mount thread

 

[oldblue]

I got 16in across from peg to peg. They clear by about an inch on each side

 

[gobsoftorque89]

Thanks for the info everyone. I had everything all planned out and then I was able to scoop up a set of brackets and pegs for 60 so. Didn't have the time lately to fab up some customs.

If i get bored over the winter now i know the measurements.