New NGK DCPR9EIX plug gap?

[qhrjsdl]

i bought NGC DCPR9EIX plugs.

I will put them soon, Should I adjust gap to 0.35 ? it is 0.25 factory gaped.

Should I gap to 0.35? or just put it in ? is it ok?

 

[qhrjsdl]

some people say it should be 0.35,

some people say just put it in. no issue.

any experiences ?

 

[oh9bolt]

[up]

 

[konarider94]

.035 but be sure to gap them correctly

 

[qhrjsdl]

oh sorry not 0.25 and 0.35. .025 , .035.


If i just put with .025, it will be a problem?

 

[oh9bolt]

[down]

 

[anrkizm95]

.035 but be sure to gap them correctly

[up]

 

[netty2424]

I didn't gap mine and don't seem to have any issues.

 

[konarider94]

a smaller gap is poor for combustion. its best to run as large as gap as possible without damaging the coil and creating a weak spark.

 

[jriffe108]

gap it to .032 -.035, .025 is too small, iridium plugs have less resistance than factory coppers, your coil has more than sufficient voltage and current to perform effectively at .035 with an iridium.

 

[user_deleted]

.035 it is BUT use caution when gapping. by that i mean be very careful sliding your feeler gauge in between the ground electorde and center iridium electrode as center electrode is delicate.

 

[Zeroflat24]

i say just throw em in. I have never had an issue by not gaping a plug. Unless they are dropped on the floor and they get bent, it should be fine.