I think i messed up my TPS reset. I plugged in the Buelltooth dongle, connected and then backed out my screw to 0. I then reset the TPS, and start the motor. Well tried to start the motor. At 0% not gonna happen, so I turn in the screw until the motor runs. It runs, but backfires and stalls and revs between 900-1500rpm with no input. I take it for a spin, it goes, but when i come to a stop, it idles rough, bouncing between 1000-1500 rpm. When I look at the TPS, it only reads to 85%.
My question is, are these the symptoms you would get if I started the motor before bringing TPS to 5.5% Tomorrow I will do another TPS, Properly. Just trying to rule out a faulty sensor, or anything else before i kick this thing.
Any input is appreciated!
My question is, are these the symptoms you would get if I started the motor before bringing TPS to 5.5% Tomorrow I will do another TPS, Properly. Just trying to rule out a faulty sensor, or anything else before i kick this thing.
Any input is appreciated!
