thrstrmech
Well-known member
trunk hole covers if you're not running the passengers foot peg brackets. used .020" aluminum, cut 1-1/2" x 1-1/2", round the corners off, tabs are 1-3/4"ish x 1/2". bend the plates to contour the trunk. drilled .040" holes and riveted with countersunk rivets. flex the tabs upward a bit to slip into the hole in one direction, when the tab clears the opening, push into place covering the hole. the plate will over lap the hole by maybe a 1/16" all around. just need to paint 'em afterwards
